Santhuff Steel Double Adjustable / Rear Shock Adjustment Procedure

1. Set shock in vertical position.
2. Turn rebound adjuster (aluminum eye w/window) clockwise until it stops.
3. Turn rebound adjuster 12 windows counter-clockwise.
4. Turn bump adjuster hex knob clockwise until stops.
5. Turn bump adjuster hex knob counter-clockwise 10 clicks.
6. Stroke shock 5 or 6 times to be able to prime the valving to avoid cavitation (After laying horizontal the fluid is displaced).
7. Turn rebound adjuster clockwise until it stops again. The shock is then at it's full firm rebound (extension) position.
8. Turn bump adjuster hex knob clockwise until it stops. The shocks bump adjuster is then at it's full firm (compression) position also.
9. Do not turn the rebound adjuster more than 21 windows (O-ring damage could occur).
10. The bump adjuster hex knob can be turned till it stops.

Baseline Setting for Steel Body Rear Shocks Drag Radial Cars

For radial cars we prefer the shock to be mounted so that there is 4" of extension from Ride Height and with a short and high instant center. The following adjustments are based with all sweeps or clicks starting from a full tight adjustment (clockwise) position. Start the rears set at 12 sweeps on the rebound adjustment and 10 clicks on the compression setting.

Baseline Setting for Steel Body Rear Shocks:

The following adjustments are based with all sweeps or clicks starting from a full tight adjustment (clockwise) position. All Rear shock baselines are with shock mounted so there is 2" of travel in either direction and an IC of about 46"-48" long and 6"-8" high. Extra long, short or low IC will not react the same.

Printed from https://www.santhuffshocks.com

Santhuff's Suspension Specialties Inc.
12886 County Road 1394
Sinton, Texas 78387
361-364-3169